Keep SKF bearings lubricated and clean, it is important to

When we inspect the bearings should be cleaned before SKF bearing surfaces, then carefully check the SKF bearing seal and the surrounding parts, if have shown adverse symptoms, be sure to replace the lost, poor seal can cause damage, so SKF Bearing cloud is not normal and can cause equipment downtime.
2 We also check the SKF bearing lubricant
Lubrication is very important, not only for SKF bearings, but also for all of the Stainless steel slewing bearing  Note, however, SKF Bearings should not add too much grease. Then SKF bearing lubricant is to replace it. Use oil-lubricated bearings in addition to the old oil spilled after, if you can, should and then poured fresh oil and let the machine at low speed rotation a few minutes. Residual oil to collect as much as possible contaminants, and then spilled addition to these oils. The use of grease lubrication SKF bearings in the replacement of grease to use when Joe devices should be avoided except in contact with cotton to any part of SKF bearings. Because these residual fibers may wedged in between rolling parts and cause damage, especially small bearing applications should pay more attention this issue.
3 Note that cover exposed SKF bearings
Check the SKF bearings, do not let the bearing exposed to contaminants or moisture. If the work is interrupted, should be oiled paper covered plastic or similar material once the machine. If the check is performed without removing the case may be cleaned under no masking the bearing, to use a brush to coat with oil coating solvent cleaning, then a dry lint-free cloth or compressed air (be careful not to let the starting rotational bearing assembly). Similar to a small mirror and dental probe used to check that the bearing surface of the track, the holder and beads. Encryption can not be cleaned dust cover or bearing; just wipe the external surfaces can be. If the bearing was damaged when the case is to be replaced. In the periodic maintenance shutdown period replace the bearings than front bearing damage due to sudden shutdown of the selected loss of more economic and more.